What’s included in a basic wastewater treatment system?
As mentioned above, the exact components of a wastewater treatment system depend on the wastewater characterization in relation to regulatory requirements for discharge from the plant, but in general, a basic wastewater treatment system typically includes some type of:
- clarifier to settle suspended solids that are present as a result of treatment
- chemical feed to help facilitate the precipitation, flocculation, or coagulation of any metals and suspended solids
- filtration to remove all the leftover trace amounts of suspended solids (again, the level of filtration needed will depend on the degree of suspended solids removal required to pass local discharge regulations)
- Final pH adjustment and any post treatment
- control panel (depending on the level of automated operation needed)
Depending on the needs of your plant and process, these standard components are usually adequate, however, if your plant requires a system that provides a bit more customization, there might be some features or technologies you will need to add on. For example, for facilities that generate biological demand such as food and beverage a biological treatment system will be required to reduce the BOD (biochemical oxygen demand), etc.
How does a wastewater treatment system work?
Specific treatment processes vary, but a typical wastewater treatment facility process will usually include the following steps:
Coagulation
Coagulation is a process where various chemicals are added to a reaction tank to remove the bulk suspended solids and other various contaminants. This process starts off with an assortment of mixing reactors, typically one or two reactors that add specific chemicals to take out all the finer particles in the water by combining them into heavier particles that settle out. The most widely used coagulates are aluminum-based such as alum and polyaluminum chloride.
Sometimes a slight pH adjustment will help coagulate the particles, as well.
Flocculation
When coagulation is complete, the water enters a flocculation chamber where the coagulated particles are slowly stirred together with long-chain polymers (charged molecules that grab all the colloidal and coagulated particles and pull them together), creating visible, settleable particles that resemble snowflakes.
Sedimentation
The gravity settler (or sedimentation part of the wastewater treatment process) is typically a large circular device where flocculated material and water flow into the chamber and circulate from the center out. In a very slow settling process, the water rises to the top and overflows at the perimeter of the clarifier, allowing the solids to settle down to the bottom of the clarifier into a sludge blanket. The solids are then raked to the center of the clarifier into a cylindrical tube where a slow mixing takes place and the sludge is pumped out of the bottom into a sludge-handling or dewatering operation.
The dewatering process takes all the water out of the sludge with filter or belt presses, yielding a solid cake. The sludge water is put onto the press and runs between two belts that squeeze the water out, and the sludge is then put into a big hopper that goes to either a landfill or a place that reuses the sludge. The water from this process is typically reused and added to the front end of the clarifier.
Filtration
The next step is generally running the water overflow into gravity sand filters. These filters are big areas where they put two to four feet of sand, which is a finely crushed silica sand with jagged edges. The sand is typically installed in the filter at a depth of two to four feet, where it packs tightly. The feed water is then passed through, trapping the particles.
On smaller industrial systems, you might go with a packed-bed pressure multimedia filter versus gravity sand filtration. Sometimes, depending on the water source and whether or not it has a lot of iron, you can also use a green sand filter instead of the sand filter, but for most part, the polishing step for conventional wastewater treatment is sand filtration.
Ultrafiltration (UF) can also be used after the clarifiers instead of the gravity sand filter, or it can replace entire clarification process altogether. Membranes have become the newest technology for treatment, pumping water directly from the wastewater source through the UF (post-chlorination) and eliminating the entire clarifier/filtration train.
Disinfection
After the water flows through the gravity sand filter, the next step is typically disinfection or chlorination to kill the bacteria in the water.
Sometimes this step is done upstream before filtration so the filters are disinfected and kept clean. If your system utilizes this step prior to filtration, you will need to use more disinfectant . . . this way the filters are disinfected and kept free from bacteria (as well as the filtered water). When you add the chlorine up front you’re killing the bacteria and have less fouling. If bacteria sits in the bed, you might grow slime and have to backwash the filters more often. So it all depends upon how you’re system operates . . . whether your system is set up to chlorinate upstream (prior to filtration) or downstream (after filtration).
Distribution
If the wastewater is being reused in an industrial process, it’s typically pumped into a holding tank where it can be used based on the demands of the facility. If for municipal use, the treated water is usually pumped into a distribution system of water towers and various collection and distribution devices in a loop throughout the city.
Other possible steps to the wastewater treatment process
Lime softening
In waters where you have high hardness or sulfates, or other constituents you need to precipitate or take out, a lime and/or a lime soda process is used. It raises the pH, causing hardness and metals in the water to precipitate out. Cold, warm, or hot lime processes can be used, and each will yield a different efficiency. In general, hotter water removes more hardness.
Ion exchange softening
In some industrial and municipal applications, if there’s high hardness, there may be post treatment for the removal of the hardness. Instead of lime, a softening resin can be used; a strong acid cation exchange process, whereby resin is charged with a sodium ion, and as the hardness comes through, it has a higher affinity for calcium, magnesium, and iron so it will grab that molecule and release the sodium molecule into the water.
Special processes
As we stated above, wastewater and effluent regulations differ everywhere you go. We have discussed some of the most common steps in a wastewater treatment plant. Typically there are special process steps to treat for a specific issues, such as the removal of certain metals or organics, or to reduce TDS for recycling etc. For these various problems specific to your individual needs, careful consideration must be given for the proper method of treatment. For Source Info, Click here!
RO 200 GPD / 300 GPD FOR LABOUR CAMPS / FACTORIES
ANTI - FOAM
Ballast Water Treatment Systems
Biocides
Boiler Chemicals
Car Wash Waste Water Plants
CATALYSTS
CHEMICAL DOSING SYSTEMS
CHEMICAL FLUSHING
Chemical Free Water Treatment Of Cooling / Heating Systems
CHEMICAL TREATMENT PROGRAMS FOR WATER
CHEMICALS
CHILLED WATER TREATMENT
Chillers
Chlorine Free Purification Systems
Chlorine Tablets / Powder
Cleaners
COMPONENTS
Cooling Towers
COPPER SILVER IONIZATION SYSTEMS
COPPER SILVER IONIZATION UNITS
Corrosion
CORROSION INHIBITORS
Covering Ballast Water Treatment
DEFOAMER
Demulsifiers
Dm Plants
Dosing Systems
EMULSION BREAKER & MICRO BIOCIDES
Etc
Filter Systems
Filters
FILTRATION MEDIA ( SAND / CARBON MEDIA / ANTHRACITE )
FLOW MEASURING & WATER QUALITY INSTRUMENTS
H2S SCAVENGER
Heaters
Ion Exchangers
MANUFACTURERS OF LIQUID FILTRATION SOLUTION
MEDIA FILTERS
Membrane Processes
MOLECULAR SIEVES
NON OXIDISING BIOCIDES FOR WATER TREATMENT
OXYGEN SCAVENGER
POLYURETHANE WATERPROOFING SYSTEMS
Produce Water Treatment Plants & Services
R O / Sewage Treatment Plants
R O PLANTS
RESIN MEDIA SOFTENERS
RESINS
Ro Plants
Scale / Paraffin Inhibitors
SCALE DISPERSANTS
SCREENS & FILTRATION SYSTEMS
Sea Water
Seawater & Brine Electrochlorination Systems
SEPARATORS & DECANTERS
Sewerage Water Treatment
Softeners
SPECIALITY CHEMICALS LIKE CORROSION INHIBITORS
STATIC DISPERSANTS
TESTING KITS & INSTRUMENTS
UV TREATMENT
VESSEL INTERNALS
Waste Water
Waste Water Process
Waste Water Recycle / Reuse
WATER ANALYSIS
WATER FILTERS
WATER PUMPS
WATER SOFTENERS
Water Testing Kits
WATER TREATMENT CHEMICALS
Water Treatment Experts
Water Treatment Plants
Water Treatment Plants & Additives
Water Treatment Products
Water Treatment Services
Water Treatment Systems
Well Water
WTP / STP / GRAY WATER PLANTS